Download MSDS-U-200-B-ANG

MATERIAL SAFETY DATA SHEET
PREMTEC U-200 B SERIE
I. GENERAL INFORMATION
MANUFACTURER
WHMIS CLASSIFICATION
PREMILEC INC.
870, Cure Boivin
Boisbriand, Quebec
J7G 2A7
CLASS D DIVISION 1B, 2B
CLASS E
Phone (450) 437-0123
PRODUCT NAME:
24 hours emergency number only
(613) 996-6666 (Canutec)
CHEMICAL FAMILY: Mixture of amine compounds
Current Issue Date
January 2004
CHEMICAL NAME:
N.B.:
PREMTEC U-200B SERIE
N/A, Product is a Mixture
This MSDS becomes invalid as soon as a new edition has been published.
II. HAZARDOUS INGREDIENTS
CHEMICAL & COMMON NAME
Chemical Identity is Proprietary
*Diethyltoluenediamine
CAS#
68479-98-1
WT%
40-70
20-50
OSHA PEL
N/A
N/A
ACGIH TLV
N/A
N/A
*Designates a toxic chemical as defined by Sara Title III, Section 311,312,313 (40 CFR 372).
Boiling Range:
Vapor Pressure (mmHg):
Specific Gravity:
Vapor Density (air=1):
% Volatile (volume):
Evap. Rate (BuOAc=1):
Volatile Organic
Content (VOC):
Solubility
(Specify Solvents):
Appearance and Odour:
III. PHYSICAL CHARACTERISTICS
No data
No data
1,0
No data
No data
No data
N.A.
No data
Clear amber liquid; characteristic amine odour. Can be pigmented, coloured.
IV. FIRE & EXPLOSION DATA
Flash Point:
Above 275F(135C)
Flammable Limits (% In Air):
No data
Extinguishing Media:
Dry chemical, foam carbon dioxide, halogenated agents. Water or foam can cause
frothing.
Special Fire-Fighting Procedures:
Use water to cool fire exposed containers. Wear self-contained breathing
apparatus, with full-face piece and protective clothing.
Unusual Fire and
Explosion Hazards:
None known.
Reactivity:
Product is stable under normal conditions.
Hazardous Polymerization:
Will not occur.
Conditions to Avoid:
None known.
Hazardous Decomposition Products:
Combustion Products:
Toxic levels of ammonia. Oxides of nitrogen, carbon and some aldehydes and
ketones may also be produced.
V. STABILITY AND REACTIVITY
Incompatibility:
Strong oxidizers, air water. Isocyanates. Acids.
Reactivity conditions:
Product is stable; hazardous polymerisation will not occur. Material supports
combustion.
Hazardous products of
Decomposition:
By fire: carbon monoxide, carbon dioxide. Oxides of nitrogen. Amine. Traces of
ammonia vapours. Other aliphatic fragments which have not been determined.
VI. HEALTH HAZARDS
Primary routes of Entry:
Eye contact, inhalation, ingestion, skin contact.
ACUTE HEALTH EFFECTS:
Eye Contact:
Will cause irritation, burning, or chemical burns.
Inhalation:
Vapours or mist are irritating and may cause nasal discharge, coughing and
discomfort in hose, throat and chest. Severe overexposure may result in difficulty breathing, headache, nausea, vomiting,
drowsiness and lung damage.
Ingestion:
Ingestion of this product is expected to be toxic. Oral LD50=485 mg/kg.
Skin Contact:
This product can be toxic by dermal absorption. Dermal LD50=700mg/kg.
(U-200 B SERIE) / 2
VII. EMERGENCY FIRST AID PROCEDURES
Eye Contact:
Wash with clean water for at least fifteen minutes; get medical attention.
Inhalation:
Move individual to fresh air. If breathing has stopped apply artificial respiration;
get medical attention immediately.
Ingestion:
INDUCE VOMITING immediately by giving two glasses of water or milk to
drink; stick finger-sown throat. Never give anything to an unconscious person. Get medical attention immediately.
Skin Contact:
Immediately flush skin with plenty of water for at least 15 minutes. Remove
contaminated clothing and shoes. Get medical attention. Wash clothing and decontaminate shoes before reuse.
Chronic Health Effect:
Prolonged or repeated overexposure may result in lung damage.
Aggravated by Exposure:
Pre-existing lung or skin conditions could be aggravated by repeated exposure.
VIII. SPILL OR LEAK PROCEDURES
Material Spilled or Released:
Ventilate area. Avoid breathing vapour. Use of self-contained breathing apparatus
may be required in confined or enclosed areas. Contain any spills with dikes or absorbents to prevent migration and entry into
sewers of streams. Take up small spills with dry chemical absorbent. Large spills may be taken up with pump or vacuum and
finished off with dry chemical absorbent.
Waste Disposal Method:
Dispose of material in accordance with all federal, state and local regulations.
IX. SPECIAL PROTECTION DATA
Respiratory Protection:
trainers in their proper use.
Ventilation:
Protective Gloves:
Eye Protection:
Other Protection Clothing or
Equipment:
clothing.
Wear MSHA/NIOSH approved respirator for organic vapours. Ensure workers are
Mechanical ventilation, adequate to keep exposure below TLV is recommended.
Neoprene or nitrile rubber.
Goggles or full face shield.
Eyewash fountain and safety shower should be accessible; impervious protective
(U-200 B SERIE) / 3
X. HANDLING & STORAGE DATA
Precautions Handling and
Storage:
Store in a well ventilated, cool, dry area. Purge with nitrogen and close container
when not in use.
Other Precautions:
Store in original container; keep tightly closed. Do not reuse container for other
purposes. KEEP OUT OF REACH OF CHILDREN.
XI. OTHER INFORMATION
TSCA Information:
WHMIS Information:
All ingredients are on the TSCA Chemical Substance Inventory.
Not all ingredients are confined on the Canadian DSL (Domestic Substances List).
XII. SHIPPING DATA
T.D.G. classification:
Amines, liquid, corrosive
UN 3066, Class 8
Packing Group III
Emergency telephone number :(613) 996-6666 CANUTEC
XII. PREPARATION OF MSDS
Approved by:
Title:
Date:
N.A.
Not applicable
N.D.
Not determined
N.E.
Not established
Mario Lefebvre
Technical Manager
January 2004
(U-200 B SERIE) / 4